Wed, 05/20/2009 - 12:08
If you're going through the tutorial in documentation, the very first topic discusses how to publish a set of sample services from the basic Presto install.
Open a command window and move to the presto-install/prestocli folder. Then run either registersamples.bat (for Windows) or registersamples.sh (for Linux, Mac or UNIX). When you log into Presto and open Wires, you should see services listed in the block menus.
Sara, technical writer/jackbe
Hey,
I got Presto installed and running using the default ports, etc. Then I tried to do some tutorials for wires but was dead before I started. Unfortunately there are no services available in the services window so I can't get any further. How do I configure Presto/Wires so that I can see and access services like it shows in the tutorials? I am using MaAfee - can that get in the way? Also, I used Presto to test the database sources and all the JDBCs did not seem to be properly configured. Is that the problem?
Any help on how to fix this?
Thanks.